1. |
Disconnect the IMS control switch connector.
|
2. |
With the power IMS control switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the IMS control switch.
|
Blower Unit Components
1. Intake Seal
2. Intake Upper Case
3. Intake Actuator
4. Air Filter
5. Air Filter Cover
6. Intake Door Assembly
7. Intake Lower Case
8. NVH Pad
9. Blower Up ...
Customer Complaint Analysis Check Sheet
There are six areas where a problem can occur: wiring harness, the radio,
the CD player, and speaker. Troubleshooting enables you to confine the problem
to a particular area.
Chart 1 ...
Tail Gate Weatherstrip Replacement
(5Door)
1.
Remove the tail gate weatherstrip (A).
...