Kia Forte: Power Window Motor Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Power Windows / Power Window Motor Inspection

Front Power Window Motor Inspection

1.	Remove the front door trim. (Refer to Body - "Front Door Trim")

2.	Disconnect the connector from the motor. [2 Door] [4/5 Door]

3.	Connect the motor terminals No.2 and No.3 directly to battery voltage (12V) and check that the motor operates smoothly. If the operation is abnormal, replace the motor. [Safety Power Window]

4.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor. [General Power Window]

Rear Power Window Motor Inspection

1.	Remove the rear door trim. (Refer to Body - "Rear Door Trim")

2.	Disconnect the 2P connector from the motor.

3.	Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

Power Window Motor Circuit Diagram

...

Power Window Switch Circuit Diagram

Driver Power Window Switch [Driver/Passenger Safety] [Driver Auto Down] Passenger Power Window Switch Rear Power Window Switch ...

See also:

Water pump Components
1. Water pump pulley 2. Water pump 3. Water pump gasket ...

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

BJ Boot Components
1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 1 ...

Categories

Copyright © www.kifomanual.com 2014-2026