Kia Optima Manuals

Kia Forte: Rear Door Module Replacement - Rear Door - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Door Module Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Replacement

(4Door, 5Door)
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Disconnect the rear door main connector (A).
3.
Disconnect the rear door latch connector (A).
4.
After loosening the mounting bolts, then remove the rear door module (A).
Tightening torque :
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

5.
Remove the rear door main connector pad (A) and mounting clip (B).
6.
Disconnect the connectors and rear door module wiring harness (A).
7.
Reomove the rear speaker .
(Refer to Body Electrical System - "Speakers")
8.
Remove the rear power window motor.
(Refer to Body Electrical System - "Power Window Motor")
9.
Install in the reverse order of removal.
  
•
The area of whole parts should be applied with sufficient grease.
•
Make sure connectors are connected properly and each rod is connected securely.
•
Make sure the door locks/unlocks and opens/closes properly
Rear Door Module Component Location
(4Door, 5Door) 1. Rear door module ...

Rear Door Outside Handle Component Location
(4Door, 5Door) 1. Rear door outside handle ...

See also:

Auto Light Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the auto light sensor (A) from crash pad upper side by using screw (-) driver. ...

In-car Sensor (DATC only) Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the center fascia panel. (Refer to Body - "Center Fascia Panel") ...

Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure must be performed.    1. ...

Categories

Copyright www.kifomanual.com 2014-2026