Kia Forte: Rear Glass Defogger Switch Replacement
| 1. |
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
|
| 2. |
Remove the cluster fascia panel.
(Refer to Body - "Cluster Fascia Panel")
|
| 3. |
After loosening the mounting screws, remove the drive airvent
duct assembly (A).
|
| 4. |
After loosening the mounting screws, disconnect the connector
(A), and then remove the center fascia cover (B).
|
| 5. |
Disconnect the clock switch connector (A).
|
| 6. |
After loosening the mounting screws, remove the center airvent
duct assembly [RH] (A).
|
| 7. |
Remove the in-car hose (A).
|
| 8. |
Disconnect the in-car sensor connector (B).
|
| 9. |
After loosening the mounting screws, remove the A/C & heater controller
(A).
|
| 10. |
Disconnect the A/C & heater controller connector (A).
|
| 11. |
Install in the reverse order of removal.
|
Rear Glass Defogger Switch InspectionMode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Camshaft Position Sensor (CMPS) Installation
•
Install the component with the specified torques.
•
...
SS-A Solenoid Valve(ON/OFF) Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...