Kia Forte: Rear Oil Seal Removal - Cylinder Block - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Oil Seal Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Removal

1.
Remove the automatic transaxle.
(Refer to Automatic Transaxle System - "Automatic Transaxle")
Remove the manual transaxle.
(Refer to Manual Transaxle System - "Manual Transaxle")
2.
Automatic transaxle : Remove the drive plate.
(Refer to Cylinder Block – “Drive Plate”)
Manual transaxle : Remove the flywheel.
(Refer to Cylinder Block – “Flywheel”)
3.
Remove the rear oil seal (A).

Rear Oil Seal Components
1. Rear oil seal ...

Rear Oil Seal Installation
1. Install a new rear oil seal. (1) Apply engine oil on the edge of new oil seal. (2) ...

See also:

TPMS Receiver
1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. ...

Variable Charge Motion Actuator (VCMA) Specification
Motor Item Specification Coil Resistance (Ω) 3.4 ~ 4.4 [20°C(68°F)] Position sensor Item Specification Coil Res ...

Installation
1. Install in the reverse order of removal. 2. Adjust the ignition lock switch. (1) In state of full stro ...

Copyright www.kifomanual.com 2014-2026