Kia Forte: Rear Pillar Trim Replacement
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Using a screwdriver or remover, remove the rear pillar trim (A).
|
2. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
(5Door)
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the rear wheel house trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
|
2. |
After loosening the mounting bolts, then remove the rear pillar
trim (A).
|
3. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
(2Door)
•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
•
|
Take care not to bend or scratch the trim and panels.
|
|
1. |
Remove the rear inner outer trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
2. |
After loosening the mounting bolts, then remove the rear pillar
trim (A) by using a screw driver.
|
3. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
(4Door)
1. Rear pillar trim
(5Door)
1. Rear pillar trim
(2Door)
1. Rear pillar trim
...
(4Door)
1. Rear wheel house trim
(5Door)
1. Rear wheel house trim
...
See also:
Installation
•
If the oil seal on the transaxle case side is damaged
and fluid is leaking, replace th ...
DC/DC Converter Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown
while “Auto Starting” or “Idle Starting”functi ...
Engine overheat
If your temperature gauge indicates overheating, you will experience a loss of
power, or hear loud pinging or knocking, the engine is probably too hot. If this
happens, you should: 1.Pull off the ro ...