Kia Forte: Removal
| 1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Remove the smart junction box.
(Refer to Body Electrical System - "Relay Box (Passenger Compartment)")
|
| 3. |
Disconnect the ignition lock switch connector (A).
|
| 4. |
Remove the ignition lock switch by loosening a nut (A).
|
Inspection
Component Inspection
1.
Remove the ignition lock switch.
2.
Push the ignition lock switch in the direction of the arrow to
make sure t ...
Installation
1.
Install in the reverse order of removal.
2.
Adjust the ignition lock switch.
(1)
In state of full stro ...
See also:
In-car Sensor (DATC only) Inspection
1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air
inlet. Measure the sensor resistance betwe ...
Inspection
1.
Inspect diaphragm spring wear which is in contact with a clutch
release bearing.
2.
Check the clutch cover and disc surface for wear or ...
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Copyright © www.kifomanual.com 2014-2025