Kia Forte: Troubleshooting - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Troubleshooting

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Troubleshooting

Symptom
Suspect Area
Remedy (Refer to page)
Water leaks from sunroof
Dirt accumulated in drain tube
Clear dirt inside of drain
Clogged drain tube
Blow air into drain to remove dirt
Broken or dislocated drain tube, defective or cracked clip
Check tube installation and flange contact
Deteriorated roof lid weatherstrip
Replace
Excessive roof lid-to-body clearance and improperly fitted weatherstrip
Adjust
Wind noise around sunroof
Loosen or deformed deflector, gaps in body work
Retighten adjust or replace
Sunroof lid makes a noise when move
Foreign particles lodged in guide rail
Check drive cable and guide rails for foreign particles
Loosen guide rails and lid
Retighten
Motor runs but sunroof does not move or moves only partially
Foreign particles lodged in guide rail
Adjust or replace
Incorrect engagement of motor pinion with drive cable
Decrease in motor`s clutch slipping force
Increased sunroof sliding resistance or interference of sunroof with drive cables, weatherstrip, etc. due tomal adjustment of sunroof
Noise in motor (clutch slipping noise from motor when sunroof is fully opened or closed is not an unusual noise
Incorrect engagement of motor pinion with drive cable
Check pinion installation and Re-tighten motor
Worn out or damaged motor pinion bearing
Replace motor assembly
Worn out or deformed drive cable
Replace
Door glass fails to operate up and down
Incorrect window glass installation
Adjust position
Damaged or faulty regulator arm or regulator
Correct or replace
Glass operation switch fault
Replace
Door does not open or close completely
Incorrect door installation
Adjust position
Defective door check assembly
Correct or replace
Door hinge requires grease
Apply grease
The striker and latch location is not correct
Adjust
Noise occurs when operating the door
Excessive dust or lack of grease
Remove the dust and apply grease
Hood does not open or close completely
Striker and latch not properly aligned
Adjust
Incorrectly installed hood
Adjust
Incorrect hood bumper height
Adjust
Water leak through windshield end rear window
Defective seal
Fill with sealant
Defective flange
Correct

Special Service Tools
Tool (Number and name) Illustration Use 09880-4F000 Hog ring clip installer Hog ring clip installation ...

Body Dimensions
...

See also:

DC/DC Converter Operation Principle
   • In the ISG mode, if the power of an audio system turns OFF by drawdown while “Auto ...

Underdrive Brake Control Solenoid Valve(UD/B_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Front Fog Lamps Installation
1. Install the front fog bulb. 2. Reconnect the lamp connector. 3. Install the front bumper cover. ...

Copyright © www.kifomanual.com 2014-2024