Kia Forte: Trunk Lid Assembly Replacement
| •
|
Wear gloves to protect hands from injury.
|
|
| •
|
When removing and installing the trunk lid, an assistant
is necessary.
|
|
|
1. |
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
|
|
2. |
Disconnect the connectors and trunk lid wiring harness (A).
|
|
3. |
After loosening the mounting bolts, then remove the trunk lid
assembly (B).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
|
4. |
Install in the reverse order of removal.
|
• |
Make sure the trunk lid locks/unlocks and opens/closes
properly.
|
|
• |
Adjust the trunk lid alignment.
|
|
• |
Make sure the connectors are connected in properly.
|
|
• |
Replace any damaged clips.
|
|
|
(4Door, 2Door)
1. Trunk lid assembly
...
(4Door, 2Door)
1. Trunk lid trim
...
See also:
Fuses
A vehicle's electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver's side panel bolster,
others in the engine ...
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Mode Control Actuator Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the mode control actuator connector.
3.
Verify that the mode con ...
Trunk Lid Assembly Component Location
Trunk Lid Trim Component Location