Kia Forte: Trunk Lid Latch Replacement - Trunk Lid - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Trunk Lid Latch Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Latch Replacement

(4Door)
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the trunk lid latch connector (A) and remove the trunk lid latch cable (B).

3.
After loosening the mounting bolts, then remove the trunk lid latch assembly (A).

Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Install in the reverse order of removal.
  
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Adjust the trunk lid alignment.
•
Make sure the connectors are connected in properly.
(2Door)
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the trunk lid latch connector (A) and remove the trunk lid latch cable (B).
3.
After loosening the mounting bolts, then remove the trunk lid latch assembly (C).

Tightening torque :
6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

4.
Install in the reverse order of removal.
  
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Adjust the trunk lid alignment.
•
Make sure the connectors are connected in properly.
Trunk Lid Latch Component Location
(4Door) 1. Trunk lid latch assembly (2Door) 1. Trunk lid latch assembly ...

Trunk Lid Weatherstrip  Replacement
(4Door, 2Door) 1. Remove the trunk lid weatherstrip (A).    ...

See also:

Inspection
Lighting Switch Inspection With the multifunction switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the mul ...

Failure Diagnosis
1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...

Front Lower Arm Inspection
1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. 3. Check th ...

Copyright � www.kifomanual.com 2014-2026