Kia Forte: Water pump Removal and Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Water pump Removal and Installation
| 1. |
Loosen the drain plug, and then drain the engine coolant. Remove
the radiator cap to help drain the coolant faster.
|
| 2. |
Remove the drive belt.
(Refer to Timing System – “Drive Belt”)
|
| 3. |
Remove the water pump pulley (A).
|
| 4. |
Remove the water pump assembly (A) with the gasket (B).
|
| 5. |
Install in the reverse order of removal.
|
| 6. |
Fill the engine coolant.
|
| 7. |
Start the engine and check for leaks.
|
| 8. |
Recheck the coolant level.
|
Water pump Components
1. Water pump pulley
2. Water pump
3. Water pump gasket
...
Water pump Inspection
1.
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
2.
Check the bearing for damage, abnorm ...
See also:
Operating door locks from outside the vehicle
Turn the key toward the rear of the vehicle to unlock and toward the front
of the vehicle to lock.
If you lock/unlock the door with a key, all vehicle doors will lock/unlock
automatically ...
SRS Control Module (SRSCM)
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that does not. The ...
Fuel Tank Pressure Sensor (FTPS) Specification
Pressure [kPa (kgf/cm², in H2O)
Output Voltage (V)
-6.67 (-0.068, -26.8)
0.5
0
2.5
+6.67 (0.068, 26.8)
4.5
...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026