Kia Forte: Accelerator Position Sensor (APS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), the nuts (C) and then remove
the accelerator pedal module.
|
Accelerator Position Sensor (APS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...
Accelerator Position Sensor (APS) Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...
See also:
Tire Installation
1.
Apply tire soap or lubrication to the top and bottom tire beads.
2.
To fit the bottom bead, position the valve at the 5 o’clock posit ...
Special Service Tools
Tool(Number and Name)
Illustration
Use
09581-11000
Piston expander
Spreading the front and rear disc brake piston.
...
Telemetics Unit (TMU) Component
Connector Pin Specification
No.
Pin Name
Type
From
To
Description (Wiring
Spec.)
1
GND
DC Ground
TMU
Batt ...
Copyright © www.kifomanual.com 2014-2024