Kia Forte: Adjustment
| Stop lamp switch clearance adjustment |
If the gap between stop lamp switch and bracket is not 1.0 ~ 2.0mm(0.04~
0.08in), conform to below.
| 1. |
Disconnect the stop lamp switch connector (A).
|
| 2. |
Pull the locking plate (A) as indicated by the arrow.
|
| 3. |
Turn stop lamp switch 45° counterclockwise and remove it.
|
| 4. |
Fix the brake pedal arm and insert fully the stop lamp switch
as hiding contact part.
|
| 5. |
After inserting, turn the stop switch 45° clockwise, and then
assemble locking plate by pushing.
|
| 6. |
Confirm the gap between stop lamp switch and bracket.
|
| 7. |
Connect the stop lamp switch connector.
|
Installation
1.
Pre-tighten the bracket fixing bolt (A) in dash panel.
2.
Install the brake booster and brake pedal member fixing nuts (A)
secur ...
Front Disc Brake
Components
1. Guide rod bolt
2. Bleed screw
3. Caliper carrier
4. Caliper body
5. Inner pad shim
6. Brake pad
7. Pad retainer
...
See also:
Compressor Disassembly
1.
Remove the front right side tire.
2.
Remove the engine room side cover (A).
3.
Remove the wheel guar ...
Component Location
1. Driver power window switch
2. Door lock switch (Driver)
3. Passenger power window switch
4. Door lock switch (Passenger)
5. BCM (Body Control Module)
6. Front door loc ...
A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) converts the pressure value of high
pressure line into voltage value after measuring it. By converted voltage value,
engine ECU controls the cooling fan by o ...
Copyright © www.kifomanual.com 2014-2024