|
1. |
Remove the front door trim.
(Refer to Front Door - "Front Door Trim")
|
2. |
Remove the front door window glass mounting hole plug.
|
3. |
Carefully move the front door window glass (A) until the glass
mounting bolts are visible, then loosen them.
(4Door, 5Door)
(2Door)
|
4. |
Check that the glass moves smoothly.
|
|
1. |
Loosen the screws (B) just enough for the striker to move.
|
2. |
Tap on the striker with a plastic hammer to adjust the striker.
The striker will not move much, but will give some adjustment.
|
3. |
Hold the outer handle out, and push the door against the body
to be sure the striker allows a flush fit. If the door latches properly,
tighten the screws and recheck.
|
|
1. |
Check that the door and body edges are parallel.
|
2. |
Place the vehicle on a firm, level surface when adjusting the
doors.
|
3. |
Adjust at the hinges (A) :
(4Door, 5Door)
(2Door)
|
4. |
Grease the pivot portions of the hinges indicated.
|
5. |
Check for water leaks.
|
Specification
Air Conditioner
Item
Specification
Compressor
Type
6VS14 (MTC) / 6VSE14 (DFATC)
Oil type & Capacity
PAG(FD46XG) 110±10cc
...
Components
1. Control shaft complete
2. Back-up lamp switch
3. Vehicle speed sensor
4. Transaxle housing
5. Transaxle case
...
Door Scuff Trim Component Location
(4Door, 5Door)
1. Front door scuff trim
2. Rear door scuff trim
(2Door)
1. Front door scuff trim
...