Clutch Release Cylinder Air Bleeding Procedure |
|
1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
2. |
Refill the clutch master cylinder with the specified fluid.
|
3. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
5. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and re-tighten it with the pedal pressed. Raise it again, then.
|
6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
|
7. |
Refill the clutch master cylinder with the specified fluid.
|
Front Door Module Replacement
1.
Remove the front door window glass.
(Refer to Front Door - "Front Door Window Glass")
2.
Disconnect the front door main con ...
ETC (Electronic Throttle Control) System Installation
•
Install the component with the specified torques.
•
...
Rear Wheel House Trim Replacement
(4Door)
•
Put on gloves to protect your hands.
...