Kia Forte: Adjustment
| Transaxle Control Module(TCM) Learning |
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
| • |
TCM replacement
|
| • |
TCM upgrading
|
| TCM learning procedure |
| 1. |
Automatic Transaxle Fluid (ATF) temperature: 40~100°C (104~212°F)
|
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping
on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st, 2nd,
3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified Throttle Position Sensor (TPS) value (15~25%).
|
Control System Composition
Fault Diagnosis
Features a fail-safe mechanism that provides "limp-home" 4th gear hold
to enable the vehicle to be driven to the owner's home or dealer shop.
Fail-Safe: ...
Circuit Diagram
...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the Solenoid valve connector.
3.
Measure resistance between sensor ...
Flat tire
For safe operation, carefully read and follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tire Mobility Kit is a temporary fix to the tire and the tire sh ...
Shift Cable Installation
1.
Install in the reverse order of removal.
•
...
Copyright © www.kifomanual.com 2014-2024