Kia Forte: Alternator On-vehicle Inpection - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Alternator On-vehicle Inpection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator On-vehicle Inpection

  
Check that the battery cables are connected to the correct terminals.
Disconnect the battery cables when the battery is given a quick charge.
Never disconnect the battery while the engine is running.
Check The Battery Terminals And Fuses
1.
Check that the battery terminals are not loose or corroded.
2.
Check the fuses for continuity.
Inspect Drive Belt
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
  
Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.

Alternator Specification
Item Specification Rated voltage 13.5V, 120A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator built-in type ...

Alternator Removal
1. Disconnect the battery negative (-) cable. 2. Remove the drive belt. (Refer to Engine Mechanical System - "Timing Chain") ...

See also:

Opening the tailgate
The tailgate is locked or unlocked when all doors are locked or unlocked with the transmitter (or smart key) or central door lock switch. If unlocked, the tailgate can be opened by pressing ...

Front Hub / Knuckle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Cylinder Head Cover Components
1. Cylinder head cover 2. Cylinder head cover gasket ...

Copyright © www.kifomanual.com 2014-2024