Kia Forte: Alternator Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / Alternator Removal
| 1. |
Disconnect the battery negative terminal.
|
| 2. |
Remove the drive belt.
(Refer to Engine Mechanical System - "Drive Belt")
|
| 3. |
Disconnect the alternator connector (A) and the cable (B) from
alternator "B" terminal.
|
| 4. |
Pull out the through bolt and then remove the alternator (A).
|
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14 (0.1 ~ 5.1,1.42 ~ 72.54)
Current value(mA)
...
Room lamp
To turn the room lamp ON or OFF, push the switch.
If your vehicle is not equipped with a map lamp, the room lamp will also turn
on or off as follows.
The room lamp comes on when a door is opene ...
Spark Plug Description
A spark plug is a device for delivering electric current from an ignition
system to the combustion chamber of a spark-ignition engine to ignite the compressed
fuel/air mixture therein by mean ...
Copyright © www.kifomanual.com 2014-2024