Kia Forte: Auto Head Lamp Leveling Unit Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Auto Head Lamp Leveling Device / Auto Head Lamp Leveling Unit Inspection
| 1. |
Ignition "ON".
|
| 2. |
Turn on the head lamp switch.
|
| 3. |
Check for operation. If the aim of the head lamps changes smoothly
when the head lamp leveling switch is turned.
|
| 4. |
If the operation does not work well, inspect the connector and
terminals to be sure they are all making good contact.
If the terminals are bent, loose or corroded, repair them as necessary,
and recheck the system.
If the terminals look OK, go to step 5.
|
| 5. |
Substitute with a known-good head lamp assembly and check for
proper operation.
|
Auto Head Lamp Leveling Unit Operation
Operating Procedure
1.
Suspension angle change resulted from vehicle's load change.
2.
Sensor angle change.
3.
...
Auto Head Lamp Leveling Unit Removal
1.
Remove the head lamp leveling unit connector (A).
2.
Remove the head lamp leveling unit (B) after loosening the mounting
bolts.
...
See also:
Main Crash Pad Assembly Component Location
1. Main crash pad assembly
...
Auto Defogging Sensor Description
The auto defogging sensor is installed on the front windshield glass.
The auto defogging sensorr senses moisture on the windshild. The air conditioner
control module receives the signal from ...
Interior
Interior A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Interior B
* These dimens ...
Copyright © www.kifomanual.com 2014-2024