Kia Forte: Auto Light Sensor Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the auto light sensor (A) from crash pad upper side by
using screw (-) driver.
|
| 3. |
Remove the auto light connector (B).
|
Auto Light Sensor Inspection
In the state of IGN1 ON, when multifunction switch module detects auto
light switch on, tail lamp relay output and head lamp low relay output are controlled
according to auto light sensor' ...
Auto Light Sensor Installation
1.
Reconnect the auto light connector.
2.
Install the auto light sensor.
...
See also:
Valve Body Components Location
1. Pressure Controle Valve(PCV) adjust screw
2. Solenoid valve
3. Oil temperature sensor
4. Accumulator
5. Low & Reverse Brake(LR/B) pressure flow hole
6. Underdrive ...
Photo Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
With a flat-head screwdriver, remove the photo sensor (A) from
the center of the defros ...
Line Pressure Control Solenoid Valve Description
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
Copyright © www.kifomanual.com 2014-2024