Kia Forte: BJ Boot Components
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / BJ Boot Components
| 1. BJ assembly 2. Circlip 3. BJ boot band 4. BJ boot |
5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band |
9. TJ boot 10. Spider assembly 11. Snap ring 12. TJ case |
13. Circlip |
Dynamic Damper Installation
1.
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
2.
Install the dynamic damper.
...
BJ Boot Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refer to ...
See also:
Auto Head Lamp Leveling Unit Circuit Diagram
...
Variable Charge Motion Actuator (VCMA) Specification
Motor
Item
Specification
Coil Resistance (Ω)
3.4 ~ 4.4 [20°C(68°F)]
Position sensor
Item
Specification
Coil Resis ...
Engine Coolant Temperature Sensor (ECTS) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
Copyright © www.kifomanual.com 2014-2024