Commercial hot waxes applied by automatic car washes have been known to make the windshield difficult to clean.
Contamination of either the windshield or the wiper blades with foreign matter can reduce the effectiveness of the windshield wipers.
Common sources of contamination are insects, tree sap, and hot wax treatments used by some commercial car washes. If the blades are not wiping properly, clean both the window and the blades with a good cleaner or mild detergent, and rinse thoroughly with clean water.
CAUTION - Wiper blades
To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
Blade replacement
When the wipers no longer clean adequately, the blades may be worn or cracked, and require replacement. To prevent damage to the wiper arms or other components, do not attempt to move the wipers manually.
The use of a non-specified wiper blade could result in wiper malfunction and failure.
Front windshield wiper blad
Type A
CAUTION - Wiper arms
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windshield.
1. Raise the wiper arm and turn the wiper blade assembly to expose the plastic locking clip.
2. Compress the clip (1) and slide the blade assembly downward (2).
3. Lift it off the arm.
4. Install the blade assembly in the reverse order of removal.
Type B
1. Raise the wiper arm.
CAUTION
Do not allow the wiper arm to fall against the windshield, since it may chip or crack the windscreen.
2. Lift up the wiper blade clip. Then pull down the blade assembly and remove it.
3. Install the new blade assembly in the reverse order of removal.
35R Clutch Control Solenoid Valve(35R/C_VFS) Description
35R Clutch (35R/C) Control Solenoid Valve is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R clutch.
...
Sunroof Guide Replacement
1.
Remove the sunroof assembly.
(Refer to Sunroof - "Sunroof Assembly")
2.
Remove a drip link assembly (A) after lowering a gu ...
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by the signal from the control unit. Pressing the intake selection switch
will shift between recirculation and ...