Kia Forte: Brake Switch Removal - ISG (Idle Stop & Go) System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Brake Switch Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Switch Removal

1.
Turn ignition switch OFF.
2.
Remove the crash pad lower panel. (Refer to the Body group-"crash pad")
3.
Disconnect the stop lamp switch connector (A).

Brake Switch Inspection
1. Connect a circuit tester to the connector of stop lamp switch, and check whether or not there is continuity when the plunger of the stop lamp switch is pushed in an ...

Brake Switch Installation
1. Install in reverse of removal. ...

See also:

Rear Seat Belt Retractor Component Location
(4Door, 2Door) 1. Rear seat belt retractor (5Door) 1. Rear seat belt retractor ...

Overhead Console Lamp Removal
1. Disconnect the negative (-) battery terminal. 2. Loosen 2 screws holding the overhead console (A). 3. ...

Scheduled maintenance service
Follow the Normal Maintenance Schedule if the vehicle is usually operated where none of the following conditions apply. If any of the following conditions apply, follow the Maintenance Under Severe ...

Copyright © www.kifomanual.com 2014-2024