Kia Forte: Center Fascia Panel Replacement - Crash Pad - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Center Fascia Panel Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Crash Pad / Center Fascia Panel Replacement

  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the center garnish [LH] (A).

2.
After loosening the mounting screw, then remove the center fascia panel (A).

3.
Disconnect the hazard switch connector (A).

4.
Install in the reverse order of removal.
  
Make sure the connector are connected in properly.
Replace any damaged clips.
Center Fascia Panel Component Location
1. Center fascia panel ...

Crash Pad Upper Panel Component Location
1. Crash pad upper panel ...

See also:

Engine Cover Removal and Installation
1. Remove the engine cover (A).    • ...

Roof antenna Removal
1. Remove the rear roof trim. (Refer to Body - "Roof Trim Assembly") 2. Disconnect roof antenna connectors (A). ...

Tire Wear
1. Measure the tread depth of the tires. Tread depth [limit] : 1.6 mm (0.0630 in.) 2. If the re ...

Copyright © www.kifomanual.com 2014-2024