1. |
Check for resistance between terminals in each switch position.
|
1. |
Connect the cruise control switch connector to the control switch.
|
2. |
Measure voltage between terminals on the harness side connector
when each function switch is ON (switch is depressed).
|
3. |
If not within specification, inspect the control switch resistance.
The measuring resistance value is not within specification, replace
the switch and measure the voltage again.
|
4. |
If resistance is OK but, measuring voltage is not within specification,
inspect the wiring harness and connectors between the switch and the
ECM.
|
Exterior overview
1. Hood
2. Head lamp
3. Fog lamp
4. Wheel and tire
5. Outside rearview mirror
6. Front windshield wiper blades
7. Windows
8. Parking assist system
9. Front removable towing hook
10. D ...
Removal
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray ...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the vacuum pump connector (A).
...