|
|
1. |
Remove the cylinder head cover.
(Refer to Cylinder Head Assembly - “Cylinder Head Cover”)
|
2. |
Set No.1 cylinder to TDC (Top dead center) on compression stroke.
|
3. |
Remove the crankshaft damper pulley.
(Refer to Timing System - “Crankshaft Damper Pulley”)
|
4. |
Remove the service plug bolt (A) with the gasket (B).
|
5. |
Remove the tensioner arm bolt (A).
|
6. |
Push down the tensioner arm (A).
|
7. |
Remove the camshaft bearing caps.
|
8. |
Remove the exhaust camshaft (A) first, then intake camshaft (B).
|
9. |
Remove the tensioner arm (A).
|
10. |
Remove the CVVT assembly (A) from the camshaft.
|
Temperature Control Actuator Replacement
[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -& ...
Radiator Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
2.
...
Cylinder Head Installation
•
Thoroughly clean all parts to be assembled.
•
...