1. |
Remove gasket material.
Using a gasket scraper, remove all the gasket material from the
top surface of the cylinder block.
|
2. |
Clean cylinder block
Using a soft brush and solvent, thoroughly clean the cylinder
block.
|
3. |
Inspect top surface of cylinder block for flatness.
Using a precision straight edge and feeler gauge, measure the
surface contacting the cylinder head gasket for warpage.
|
4. |
Inspect the cylinder bore
Visually check the cylinder for vertical scratches.
If deep scratches are present, replace the cylinder block.
|
5. |
Inspect the cylinder bore diameter.
Using a cylinder bore gauge, measure the cylinder bore diameter
at position in the thrust and axial direction.
|
Knock Sensor (KS) Description
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
Installation
1.
Remove ignition key from the vehicle.
2.
Disconnect the negative (-) cable from battery and wait for at
least thirty seconds.
...
Removal
The side airbag cannot be disassembled from the seat back assembly,
so replace assembly when replacing the side airbag.
...