1. |
Assemble the other parts in the reverse order of disassembly.
|
In case the cylinder block is replaced with a new one, select
the proper crankshaft main bearing and the piston according to the crankshaft
journal bore mark and the cylinder bore mark on the cylinder block.
|
Manifold Absolute Pressure Sensor (MAPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Conditio ...
ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function
Connector [CNG-AA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #2) control output
Ignition Co ...
Using the usb device
To use an external USB device, make sure the device is not connected when
starting up the vehicle. Connect the device after starting up.
If you start the engine when the USB device is connected ...