Kia Forte: DC/DC Converter Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / DC/DC Converter Removal
| 1. |
Disconnect the battery negative (-) cable.
|
| 2. |
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
|
| 3. |
Disconnect the DC/DC converter connector (A).
|
| 4. |
Remove the DC/DC converter (A).
|
DC/DC Converter Circuit Diagram
In the ISG mode, if the power of an audio system turnsOFF by drawdown
while “Auto Starting” or “Idle Starting”functi ...
DC/DC Converter Installation
1.
Install in the reverse order of removal.
If the battery negative (-) c ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Installation
Clutch cover and disc should be replaced as a set.
1.
Apply grease on a disc spline ...
Exterior care
Exterior general caution
It is very important to follow the label directions when using any chemical cleaner
or polish. Read all warning and caution statements that appear on the label.
CAUTION - H ...
Copyright © www.kifomanual.com 2014-2024