When replacing the ECM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Perform "Key teaching" procedure with GDS.
(Refer to Body Electrical System - "Immobilizer System")
|
When replacing the ECM, the vehicle equipped with the smart key
system (Button start) must be performed procedure as below.
[In the case of installing used ECM]
[In the case of installing new ECM]
Insert the key (or press the start button) and turn it to the
IGN ON and OFF position. Then the ECM learns the smart key information
automatically.
|
1. |
Install in the reverse order of removal.
|
Front Pillar Trim Component Location
1. Front pillar trim
...
Climate control system
є
1. Fan speed control knob
2. Mode selection knob
3. Temperature control knob
4. Air conditioning button
5. Air intake control button
6. Rear window defroster button
Heating and air conditio ...
TPMS Sensor
1.
Storage State
Sensors are in this state when they first arrive at dealership.
This state is entered by LF request/command only.
Either LF request ...