1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the ECTS connector.
|
3. |
Remove the ECTS.
|
4. |
After immersing the thermistor of the sensor into engine coolant,
measure resistance between the ECTS terminals 1 and 3.
|
5. |
Check that the resistance is within the specification.
|
Hood Assembly Component Location
1. Hood assembly
...
Shift Lever Removal
1.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
2.
Remove the air duct.
3.
...
Heater Unit Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Recover the refrigerant with a recovery/ recycling/ charging station.
...