Kia Forte: Engine Coolant Temperature Sensor (ECTS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Removal

1.	Turn the ignition switch OFF and disconnect the battery negative (-) cable.

2.	Disconnect the engine coolant temperature sensor connector (A).

3.

Remove the sensor (B).

Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.

4.	Supplement the engine coolant (Refer to “Cooling System” in EM group).

Engine Coolant Temperature Sensor (ECTS) Inspection

1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS. 4. ...

Engine Coolant Temperature Sensor (ECTS) Installation

• Install the component with the specified torques. • ...

See also:

ISG OFF Switch Description
The ISG OFF switch on the crash pad lower panel can be used to deactivate the ISG function. ...

Evaporator Temperature Sensor Description
The evaporator temperature sensor will detect the evaporator core temperature and interrupt compressor relay power in order to prevent evaporator freezing by excessive cooling. ...

Starter Components
[NON-ISG Type] 1. Front bracket assembly 2. Magnet switch assembly 3. Lever 4. Reducer assembly 5. Lever stop 6. Gasket sheet 7. Yoke assembly 8. Armat ...

Categories

Copyright © www.kifomanual.com 2014-2024