Kia Forte: Engine Cover Removal and Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Engine And Transaxle Assembly / Engine Cover Removal and Installation

1.

Remove the engine cover (A).

•	To avoid damage, remove the engine cover on room temperature.

•	To avoid damage of the engine cover, do not disengage both front and rear mounting point at the same time.

2.	Install in the reverse order of removal.

Engine And Transaxle Assembly

...

Engine Room Under Cover Components

1. Under cover front pannel. 2. Engine room LH under cover 3. Engine room RH under cover ...

See also:

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Components Location
1. Purge Control Solenoid Valve (PCSV) 2. Vapor line 3. ORVR valve 4. Fuel tank air filter 5. Canister Close Valve (CCV) 6. Canister 7. Fuel Tank Pressure Sensor ( ...

TCM Terminal Input/ Output Signal
Connector [A] Pin Description Condition Input/output value Type Level 1 - 　　　 ...

Categories

Copyright © www.kifomanual.com 2014-2024