1. |
Install in the reverse order of removal.
|
2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
3. |
After installation, bleed the brake system.
(Refer to ESC bleeding of ESC system)
|
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Mode Control Actuator Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -"Crash Pad Lower Panel") ...
Luggage Side Trim Replacement
(5Door)
•
Put on gloves to protect your hands.
...