Kia Optima Manuals

Kia Forte: ESC Control Module Removal - ESC(Electronic Stability Control) System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: ESC Control Module Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / ESC(Electronic Stability Control) System / ESC Control Module Removal

1.
Turn the ignition switch OFF.
2.
Pull up the lock of the HECU connector (A) , then disconnect the connector.
3.
Remove the brake fluid from the master cylinder reservoir with a syringe.
  
•
Be sure to completely remove foreign substances from around brake fluid reservoir and cap before opening the reservoir cap. If not, it may cause contamination of brake fluid and deterioration in braking performance.
•
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
4.
Disconnect the brake tubes from the HECU by unlocking the nuts counterclockwise with a spanner.
Tightening torque:
A : 12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)
B : 18.6 ~ 22.6 N.m (1.9 ~ 2.3 kgf.m, 13.7 ~ 16.6 lb-ft)

5.
Loosen the HECU bracket nuts (A), then remove HECU and bracket.
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

  
1.
Never attempt to disassemble the HECU.
2.
Never shock the HECU.
6.
Remove the 3 bolts, then remove the bracket from HECU.
Tightening torque :
7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
ESC Control Module Components
1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module(HECU) 8. Damper 9. Bracket ...

ESC Control Module Installation
1. Install in the reverse order of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...

See also:

Blower Unit Components
1. Intake Seal 2. Intake Upper Case 3. Intake Actuator 4. Air Filter 5. Air Filter Cover 6. Intake Door Assembly 7. Intake Lower Case 8. NVH Pad 9. Blower Up ...

Parking Assist Sensor Removal
[Front Bumper] 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumpe ...

Opening the hood
1. Pull the release lever to unlatch the hood. The hood should pop open slightly. Open the hood after turning off the engine on a flat surface, shifting the shift lever to the P(Park) position f ...

Categories


Copyright © www.kifomanual.com 2014-2024