Kia Forte: ETC (Electronic Throttle Control) System Description

The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator Position Sensor (APS) is used to receive driver input. The ECM uses the APS signal to calculate the target throttle angle; the position of the throttle is then adjusted via ECM control of the ETC motor. The TPS signal is used to provide feedback regarding throttle position to the ECM. Using ETC, precise control over throttle position is possible; the need for external cruise control modules/cables is eliminated.

ECM Problem Inspection Procedure

1. TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis ground using the backside of ECM harness connector as ECM side check point. If the problem is fo ...

ETC (Electronic Throttle Control) System Schematic Diagram

...

See also:

Parking Assist System Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly&quo ...

Circuit Diagram (3)
...

Power Mosfet Inspection
1. Turn the ignition switch ON. 2. Manually operate the control switch and measure the voltage of the blower motor. 3. ...