1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the resonator and the air intake hose (Refer to “Intake
And Exhaust System” in EM group).
|
3. |
Disconnect the ETC module connector (A).
|
4. |
Disconnect the coolant hoses (B).
|
5. |
Remove the installation bolts (C), and then remove the ETC module
from the engine.
|
Rear Shelf Side Trim Component Location
(5Door)
1. Rear shelf side trim
...
Side Impact Sensor (SIS)
Side Impact Sensor (SIS) system consists of two P-SIS which are installed
at each center of the front door module (LH and RH) and two SIS which are installed
at each center pillar nearby (LH ...
Oil Pump Unit (OPU) Removal
1.
Remove the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - “Crash Pad”)
...