|
1. |
Remove the floor console to reach the adjusting nut.
|
2. |
Loosen the parking brake cable until both operating levers rest
in fully off position.
|
3. |
Bring the brake pads in their operating position by pressing the
brake pedal down several times until there is resistance.
|
4. |
Tension the parking brake cable by tightening the adjusting nut,
until the operating levers on both calipers lift from the stop, up to
a distance of (A) and (D) between operating lever (B) and stopper (C).
|
5. |
Refit the floor console.
|
6. |
Parking brake lever in the car must be in fully loosened position.
|
7. |
If the handbrake cables where changed, actuate the parking brake
a few times with maximum force to stretch the parking brake cables,
and then control adjusting as above.
|
8. |
Check the wheels of their free operation.
|
9. |
Test drive.
|
Telemetics Unit (TMU) Inspection
1.
After replacing the TMU unit, access Dealer Engineering Mode in
head unit.
(Refer to MTS system - "TMU Dealer Engineering Mode")
2 ...
Operation Condition for the ISG function
1. Auto stop or Auto start condition
(If all of the below condition are satisfied)
Items
State
Remark
Driving conditions
ISG OFF Switch
...
Release Residual Pressure in Fuel Line
There may be some residual pressure even after “Release Residual
Pressure in Fuel Line” work, so cover the hose connecti ...