Kia Forte: Removal
|
| 1. |
Release the parking brake.
|
| 2. |
Remove the rear wheel & tire.
|
| 3. |
Remove the rear brake drum (A).
|
| 4. |
Remove the upper return spring (A).
|
| 5. |
Remove the lower return spring (A).
|
| 6. |
Remove the shoe hold springs (A) and shoe hold pins (B) and then
remove brake shoe (C). Make sure not to damage the dust cover on the
wheel cylinder.
|
| 7. |
Remove the parking brake cable (A) and then remove brake shoe
(B).
|
| 8. |
Disconnect brake tubes (A) from the wheel cylinder (B).
|
| 9. |
Remove the bolts (C) and the wheel cylinder (B) from the backing
plate (D).
|
Rear Drum Brake
Components
1. Shoe hold down pin
2. Shoe adjuster
3. Upper return spring
4. Adjusting lever
5. Shoe
6. Adjusting spring
7. Lower return spring
8. Shoe hold spri ...
Installation
•
Do not spill brake fluid on the vehicle: it may damage
the paint; if brake fluid does ...
See also:
Fuel Pressure Regulator Removal
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender conn ...
Output Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...
Rear Door Inside Handle Replacement
(4Door, 5Door)
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
After loosening the moun ...
Copyright © www.kifomanual.com 2014-2024