Projected Dimensions |
1. |
These are the dimensions measured when the measurement points
are projected into the reference plane, and are the reference dimensions
used for body alterations.
|
2. |
If the length of the tracking gauge probes is adjustable, make
the measurement by lengthening one probe by the amount equivalent to
the difference in height of the two surfaces.
|
Actual-Measurement Dimensions |
1. |
These dimensions indicate the actual linear distance between measurement
points, and are the reference dimensions for use if a tracking gauge
is used for measurement.
|
2. |
Measure by first adjusting both probes to the same length (A=A').
|
Measurement Point |
1. |
Measurements should be taken at the hole center.
|
Parking Assist System Switch Installation
1.
Install the switchs and connect the switch connectors.
2.
Insatll the floor console assembly.
3.
Connect the ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Specifications
Direct control VFS[UD/B]
▷ Control type : Normal high type
Control Pressure kpa (kgf/cm², psi)
500.14 ~ 9.81 (5.1 ~ 0.1,72.54 ~ 1.42)
Current value(mA)
...
Operation
Control Specification
1.
MANUAL Operation
(1)
MANUAL Seat Operation SEAT is to be operated by MANUAL
switch Input of SEAT. SLI ...