(4Door, 5Door) |
1. |
Pull down rear door window glass by pressing the power window
glass switch.
|
2. |
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
|
3. |
Remove the rear door belt inside weatherstrip (A).
|
4. |
After loosening the mounting screws, then remove the rear door
belt outside weatherstrip (A).
|
5. |
Remove the rear door rear seal (A).
|
6. |
Loosen the rear door channel (A) mounting screw and bolt.
|
7. |
Slightly push the rear door channel (A) like the direction of
the arrow in the picture below.
|
8. |
Remove the rear door window glass mounting hole plug.
|
9. |
Carefully adjust the rear door window glass (A) until you can
see the screw, then loosen them. Separate the glass from the glass run
and carefully pull the glass out through the window slot.
|
10. |
Install in the reverse order of removal.
|
Floor Console Assembly Replacement
[Floor Console Assembly]
[M/T]
•
Put on gloves to protect your hands.
...
Components
(1)
1. Main crash pad assembly
2. Crash pad side cover [LH]
3. Crash pad side cover [RH]
4. Crash pad lower panel
5. Steering column shroud upper panel
6. Steering colum ...
Blower Motor Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor voltage does not operate well, substitute
...