Kia Forte: Glove Box Housing Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Crash Pad / Glove Box Housing Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Disconnect the stopper (B) from the glove box (A).

2.	Disconnect the air damper (A) from the glove box (B).

3.	Disconnect the pins (A) and then remove the glove box (B).

4.	Using a screwdriver or remover, remove the crash pad side cover [RH] (A).

5.	Remove the glove box hose cover (A).

6.	Remove the glove box hose (B) by sliding it upward.

7.	After loosening the mounting screws, then remove the glove box housing (A).

8.	Disconnect the glove box lamp connector (A).

9.

Installation is the reverse of removal.

•	Make sure the connector are connected in properly.

•	Replace any damaged clips.

Glove Box Housing Component Location

1. Glove box housing ...

Steering Column Shroud Panel Component Location

1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

See also:

Inspection
If any of the following conditions occur, WCS reset and accuracy check should be performed. • The WCS ECU or any of the sensors is replaced. • ...

General Features
• This audio system supports Bluetooth® hands-free and stereo-headset features. - HANDS-FREE feature: Making or receiving calls wirelessly. ...

Valve Body Installation
1. Install in the reverse order of removal. After replacement or reinstallation procedure of ...

Categories

Copyright © www.kifomanual.com 2014-2024