Kia Forte: Cowl Cross Bar Assembly Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Crash Pad / Cowl Cross Bar Assembly Replacement

•	Put on gloves to protect your hands.

•	When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.

•	Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.

•	Take care not to bend or scratch the trim and panels.

1.	Remove the cowl top cover. (Refer to "Cowl Top Cover")

2.	Remove the front wiper motor. (Refer to Body Electrical System - "Front Wiper Motor")

3.	Remove the main crash pad assembly. (Refer to Crash Pad - "Main Crash Pad Assembly")

4.	Disconnect the steering column connectors. (Refer to Steering System - "Steering Column and Shaft")

5.	Lower the steering column after loosening the mounting bolts. (Refer to Steering System - "Steering Column and Shaft")

6.	Disconnect the blower unit connectors.

7.	After loosening the mounting nut, then remove the console duct (A).

8.	Disconnect the passenger compartment junction box connectors (A).

9.	Disconnect the multi box connectors (A). [Driver's] [Passenger's]

10.	Disconnect the airbag control module (SRSCM) connector (A).

11.	Remove the wirering mounting clips (A).

12.	Disconnect the shift lever connector (B).

13.	Disconnect the connectors (A) and the mounting clips in the front pillar. [Passenger's]

14.	Disconnect the smart key unit connectors (A).

15.	Loosen the smart key unit mounting screw (B).

16.	Remove the photo sensor wirering mounting clips (A).

17.	After loosening the mounting bolts and nuts, then remove the cowl cross bar assembly (A).

18.

Install in the reverse order of removal.

•	Make sure the crash pad fits onto the guide pins correctly.

•	Before tightening the bolts, make sure the crash pad wire harnesses are not pinched.

•	Make sure the connectors are plugged in properly, and the antenna lead is connected properly.

•	Enter the anti- theft code for the radio, then enter the customer`s radio station presets.

Cowl Cross Bar Assembly Component Location

1. Cowl cross bar assembly ...

Roof Trim

...

See also:

Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required. This child seat or infant seat should be of appropriate size for the child and should be installed in accordanc ...

Towing
If the vehicle needs to be towed, call a professional towing service. Never tow vehicle with just a rope or chain. It is very dangerous. Emergency Towing There are three popula ...

Components
Input/Output Specification IMS input/output pin information No. Signal Name I/O Contents Remark A1 - - - ...

Categories

Copyright © www.kifomanual.com 2014-2024