Kia Forte: Rear Pillar Trim Replacement - Interior Trim - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Pillar Trim Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Interior Trim / Rear Pillar Trim Replacement

(4Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the rear pillar trim (A).

2.
Install in the reverse order of removal.
  
Replace any damaged clips.
(5Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear wheel house trim.
(Refer to Interior Trim - "Rear Wheel House Trim")
2.
After loosening the mounting bolts, then remove the rear pillar trim (A).

3.
Install in the reverse order of removal.
  
Replace any damaged clips.
(2Door)
  
Put on gloves to protect your hands.
  
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove the rear inner outer trim.
(Refer to Interior Trim - "Center Pillar Trim")
2.
After loosening the mounting bolts, then remove the rear pillar trim (A) by using a screw driver.

3.
Install in the reverse order of removal.
  
Replace any damaged clips.
Rear Pillar Trim Component Location
(4Door) 1. Rear pillar trim (5Door) 1. Rear pillar trim (2Door) 1. Rear pillar trim ...

Rear Wheel House Trim Component Location
(4Door) 1. Rear wheel house trim (5Door) 1. Rear wheel house trim ...

See also:

Ignition Coil Removal
1. Disconnect the battery nagative terminal. 2. Remove the engine cover. 3. Disconnect the ignition coil connec ...

Rear Torsion Beam Axle Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the rear axle carrier for cracks. ...

SS-B Solenoid Valve(ON/OFF) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Copyright © www.kifomanual.com 2014-2024