1. |
Connect the DLC cable of GDS to the data link connector (16 pins)
in driver side crash pad lower panel, turn the power on GDS.
|
2. |
Select the vehicle model and then do "CODE SAVING"
|
3. |
After selecting "CODE SAVING" menu, button "ENTER" key, then the
screen will be shown as below.
|
4. |
After removing the ignition key from key cylinder, push "ENTER"
key to proceed to the next mode for code saving. Follow steps 1 to 4
and then code saving is completed.
|
Canister Close Valve (CCV) Installation
•
Install the component with the specified torques.
•
...
Removal
Back View Camera
1.
Disconnect the negative(-) battery terminal.
2.
Open the trunk and remove the trunk lid trim.
(Refer to Body - & ...
Warning lights
✽ NOTICE - Warning lights
Make sure that all warning lights are OFF after starting the engine. If any
light is still ON, this indicates a situation that needs attention.
Air bag Warning Ligh ...