1. |
Disconnect the IMS control switch connector.
|
2. |
With the power IMS control switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the IMS control switch.
|
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...
Start/Stop Button Installation
1.
Install the start/stop button.
2.
Connect the start/stop button connector.
3.
Install the cluster fascia pan ...
Crankshaft Inspection
1.
Check the crankshaft bearing oil clearance.
(1)
To check main bearing-to-journal oil clearance, remove
the lower crankcase and lo ...