1. |
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat switch.
A : Power seat control switch
B : Lumbar support switch
|
Front Strut Assembly Disassembly
1.
Using the special tool (09546-26000), compress the coil spring
(A).
Tightening torque:
58.3 ~ 73.5N.m (6.0 ~ 7.5kgf.m, 43.4 ~ 54.2 ...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Room Lamp Installation
Room Lamp
1.
Reconnect the connector.
2.
Install the room lamp assembly.
3.
Install the lens.
...