1. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
2. |
Disconnect the connector from the motor.
[2 Door]
[4/5 Door]
|
3. |
Connect the motor terminals No.2 and No.3 directly to battery
voltage (12V) and check that the motor operates smoothly.
If the operation is abnormal, replace the motor.
[Safety Power Window]
|
4. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
[General Power Window]
|
1. |
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
|
2. |
Disconnect the 2P connector from the motor.
|
3. |
Connect the motor terminals directly to battery voltage (12V)
and check that the motor operates smoothly. Next, reverse the polarity
and check that the motor operates smoothly in the reverse direction.
If the operation is abnormal, replace the motor.
|
Windshield Wiper-Washer Switch Installation
1.
Install the multifunction switch.
2.
Install the clock spring.
3.
Install the steering column upper and lowe ...
Fuel Tank Pressure Sensor (FTPS) Circuit Diagram
(M/T)
(A/T)
...
Variant coding
After replacing the SRSCM with a new unit, the “Variant Coding” procedure
must be performed.
1.
...