1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. |
Disconnect the connector from the power window switch module.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
[Driver/Passenger Safety]
[Driver Auto Down]
|
5. |
Remove the power window switch(A) after loosening the screws.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
|
3. |
Disconnect the connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
[Auto]
[Manual]
|
5. |
Remove the power window switch(A) after loosening the screws.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear door trim panel.
(Refer to Body - "Rear Door Trim")
|
3. |
Disconnect the 8P connector from the switch.
|
4. |
Check for continuity between the terminals in each switch position
according to the table. If the continuity condition is not normal, replace
the switch.
|
5. |
Remove the power window switch(A) after loosening the screws.
|
Knock Sensor (KS) Installation
•
Install the component with the specified torques.
•
...
Parking Assist Sensor Installation
1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect t ...
Hood Assembly Replacement
•
Be careful not to damage the hood and body.
...