1. |
Loosen the windshield wiper arm nut (B) after removing a wiper
cap (A).
|
2. |
Remove the windshield wiper arm and blade.
|
3. |
If necessary, release the wiper blade fixing clip by pulling up
and remove the wiper blade from the inside radius of wiper arm.
|
4. |
Disconnect the washer hose (A) connected to cowl top cover.
|
5. |
Remove the weather strip and the cowl top cover (A) after removing
4 retainers.
|
6. |
Disconnect the wiper motor connector from the wiper motor & linkage
assembly.
|
7. |
Remove the windshield wiper motor and linkage assembly (A) after
removing 2 bolts.
|
8. |
Disconnect the connector (A) from the wiper motor.
|
9. |
Hold the wiper motor crank arm and remove the upper linkage (A)
from the wiper motor crank arm.
|
10. |
Remove the lower linkage (A) from the wiper motor crank arm.
|
11. |
Remove the crank arm (A) after loosening the mounting nut.
|
12. |
Remove the wiper motor (A) with 3 bolts.
|
Component Replacement After Deployment
Before doing any SRS repairs, use the GDS Pro to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing ...
Specifications
Transaxle type
M6CF3-1
Engine type
Gasoline 1.8 MPI / Gasoline 2.0 GDI
4/5DR
2DR
Gear ratio
1st
3.308
3.615
...
PTC Heater Inspection
Operating Logic Test (Manual only)
Inspect the PTC operation with the confirmation logic below :
1.
Entering
(1)
Set the Floor mode ...